used stainless steel prop for 25 mercury (SOLD)

Discussion in 'BUY AND SELL - MAKE $$$ - GET CHEAP DEALS' started by fishstick, Jun 27, 2009.

Thread Status:
Not open for further replies.
  1. fishstick

    fishstick New Member

    Messages:
    1,885
    State:
    Fouke, Arkansas
    i have a used 13 pitch stainless steel prop for a late model mercury 2-stroke 25 hp that i would sell for $100 plus shipping. the prop is a 10 spline and has a few dings but not nicked up. i'm going to a lower pitch and need to sell this one.
     
  2. fishstick

    fishstick New Member

    Messages:
    1,885
    State:
    Fouke, Arkansas
    this prop pushes my 16 ft xpress flatbottom at 28 mph. i have an aluminum prop of the same pitch that only goes 23 mph. so if you are running an aluminum prop on your motor you'd benefit from upgrading to a stainless prop
     

  3. fishstick

    fishstick New Member

    Messages:
    1,885
    State:
    Fouke, Arkansas
  4. puddle jumper

    puddle jumper Well-Known Member

    Messages:
    1,507
    State:
    NW.Georgia
    What brand is it??? This will fit my motor as well,,50hp merc.
    Any pics of the dings??
    Puddle
     
  5. fishstick

    fishstick New Member

    Messages:
    1,885
    State:
    Fouke, Arkansas
    this prob will probably fit your 50 but it is a little smaller diameter than what your motor calls for
     
  6. fishstick

    fishstick New Member

    Messages:
    1,885
    State:
    Fouke, Arkansas
Thread Status:
Not open for further replies.