Tattletail jug

Discussion in 'WILD WOLF TACKLE' started by ShilohRed, May 11, 2007.

  1. ShilohRed

    ShilohRed New Member

    Messages:
    4,339
    State:
    West Tn
    Been cutting the parts for my Tattletail jug's.
    Boy there easy to build, And look so good. I for one would like to Thank Gene ( AKwolf47) for making these jug kits. And also for bringing them to the gathering.
    I bought enough kits to make 36 jugs. Still have to pick up the cold-roll steel for the weights in them.
    Hope to get to fish them next week.
    Thanks again Gene.
    Pete
     
  2. ShilohRed

    ShilohRed New Member

    Messages:
    4,339
    State:
    West Tn

  3. Scott Daw

    Scott Daw New Member

    Messages:
    2,002
    State:
    Allentown, Pennsylvania
    They look good. Shame we cant jug properly here in pa. I'd have to run a line from the jug back to my hand or rod to make em legal here.
     
  4. fish

    fish Active Member

    Messages:
    1,573
    State:
    ChattanoogaTenn
    Pete, those look really good, looks like you are fixin to have some fun.
     
  5. jtrew

    jtrew New Member

    Messages:
    4,404
    State:
    Little Rock, AR
    Pete, you better watch for the barges, or you'll lose those fine-looking jugs.
     
  6. ShilohRed

    ShilohRed New Member

    Messages:
    4,339
    State:
    West Tn

    Jerry I stay with them. Also in 35 years of jug fishing, I have never lost one to a barge. Did have a few hit by fisherman flying through them though. LOL
    Pete
     
  7. jtrew

    jtrew New Member

    Messages:
    4,404
    State:
    Little Rock, AR
    I'm just the opposite. To the best of my knowledge, I've never had a jug hit by a small boat, but I've probably lost a couple of dozen over the past 23 years I've been jugging.
     
  8. TScottW99

    TScottW99 New Member

    Messages:
    44
    State:
    NRV, VA
    Thanks for letting us know how you like them. I have been looking at them and will proably pick some up here real soon.