SplashWell trim/cap?

Discussion in 'Boat Repair Help' started by DANZIG, Jun 30, 2009.

  1. DANZIG

    DANZIG New Member

    Messages:
    6,672
    State:
    West Virginia
    Aluminum boat, Standard outboard motor "U" shape transom splashwell "cutout", about 1 1/2 inches "thick".

    I am looking for a "Cap" to keep the water out. Preferably aluminum, but I will take what I can get.

    Any clues as to where to find such??
     
  2. Duckpoor

    Duckpoor New Member

    Messages:
    184
    State:
    Illinois
    Anyone with a Break can bend one up for you in about 5 min.
    Find you some sheet alum , about the right width and stop by a shop that does furnace work . Two pulls of the lever and you have a cap.

    I think he last one I had done was 5.00 and a thank you .

    ron :wink: