Catfish Angler Forum at USCA banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1,134 Posts
Discussion Starter · #1 ·
Hi Folks;
I had to put a clutch slave cylinder and master cylinder in my truck today,waiting on one small part maybe monday. I dropped Sergeants time off at bass pro and they said I have to have my carbs rebulid, So I dropped about 1,100.00. The old s10 4x4 is still running good and the boat should be great. I gotta keep it road worthy lots fishing to be done.
 

·
Registered
Joined
·
11,102 Posts
I hope Chevy has a better idea than Ford on a slave cylinder. I had a 95 F150 that had a round,,,, slave cylinder that went around the trans input shaft.

Boy was that an experience to work on. What a stupid set up!!!!!. All plastic, special fittings on the plastic line, everything touched on that clutch had to be replaced new after my hired help got done with it. lol


:angry::wink::angry:
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top