Picnic Table Rod Holders

Discussion in 'Fishing Rod Holder Review' started by Madtownangler, Aug 4, 2009.

  1. Madtownangler

    Madtownangler New Member

    Messages:
    209
    State:
    Wisconsin
    I made a couple picnic table rod holders out of scrap wood, PVC and a couple bolts with wingnuts. Pictures attached.

    I used a two inch hole cut saw on a drill and 1.5 inch PVC pipe.
     

    Attached Files:

    Last edited: Aug 4, 2009
  2. Flootie16

    Flootie16 New Member

    Messages:
    1,268
    State:
    Indiana
    thats a pretty smart design. now did you make them to where they just bolt around the picnic table so not to destroy the table? i really like them. and if i fished from the bank enough would definately have to make some of those bad boys.....very nice work!