Catfish Angler Forum at USCA banner
1 - 20 of 30 Posts

· Registered
Joined
·
9,811 Posts
Discussion Starter · #1 ·
just made me a couple bait holders for gills and minnows. the first one is made from a cooler. much to big to carry down the banks and such but for the truck and garage it should work great.

took a $6 bubble box and some tubing and got a $2 bobble stone and used marine adheasive to secure it to bottom. also attached a knife to it for easy access.

drilled a whole through the side for the tubing and used the marine sealent/ adh to seal it.

the big stone puts out more air than the small round one that came with the box.
 

· Registered
Joined
·
9,811 Posts
Discussion Starter · #3 ·
this one is a more portable one for moving bait around. took a clean 5 gal bucket and got an eliminator lid from cat connection. they are cool.

put a bubble box on the side through bucket and sealed with marine seal/ adh. drilled a whole for the air line and sealed.

attached the lid and filled with extra batteries and tackle.

also attached a knife through bucket for this one too.
 

· Registered
Joined
·
9,811 Posts
Discussion Starter · #5 ·
i figured the big one for the truck and keeping inthe garage for a few days and the other for going to the wholes. i keep some in koi pond they are just hard to retrive,lol.
 

· Registered
Joined
·
692 Posts
great idea once again jeremy.
I've got a "transpoter" tank I made from a large plastic round plumbing container. I use it ti transport bait back to the house and to the fishing hole.
I'll take some pics and post tomorrow.
 
1 - 20 of 30 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top