kicker motor bracket

Discussion in 'BUY AND SELL - MAKE $$$ - GET CHEAP DEALS' started by kyjake, Aug 25, 2009.

Thread Status:
Not open for further replies.
  1. kyjake

    kyjake New Member

    Messages:
    714
    State:
    kentucky
    Need a mounting bracket for a 5 to 10 hp. motor
    Jake
     
  2. bnt55

    bnt55 New Member

    Messages:
    640
    State:
    Northern KY
    Jake

    I have been looking for the same thing, and after pricing them I figured it might be easier to make out of welded aluminum. Just FYI
     

    Attached Files:


  3. jlcperformance

    jlcperformance New Member

    Messages:
    306
    State:
    moberly, missouri
    14 ga aluminum would be ideal for that i would think, it would be very easy to make.
     
  4. kyjake

    kyjake New Member

    Messages:
    714
    State:
    kentucky
    You all may be right in building one.14 ga. aluminum is only .064" which would be too thin,one would need at least 1/4" and a good welder to do the work.Painted steel would be much easier and stronger.
    Jake
     
  5. jogle1023

    jogle1023 New Member

    Messages:
    143
    State:
    Shepherdsville
    I have the entire thing except the "L" brakets that mount to the boat. I also have the steering kit that attaches to your big motor for steering. If anyone wants everything how about 100.00 ( the sterring kit is that much).. Thanks Jayme
     
Thread Status:
Not open for further replies.