Inexpensive bank rod holders

Discussion in 'Fishing Rod Holder Review' started by roofermike, Aug 25, 2005.

  1. roofermike

    roofermike New Member

    Messages:
    92
    State:
    Jefferson City, Missouri
    Some of you have probably seen these but I thought I would post about them any ways.

    Take a section of 2" PVC cut it about 3-4' long then measure to them middle and make a 45 degree mitre cut. You get 2 holders per section. Then just drive them into the ground. They seems to work great except in gravely areas.
     
  2. Desperado

    Desperado Active Member

    Messages:
    1,244
    State:
    Pataskala, Ohio
    Name:
    Clarence
    I did that and had one split. I made them into an A frame and they lay on top on the ground and work great!!