Fishing Rod holders

Discussion in 'Boat Tips' started by Houdini, Nov 22, 2007.

  1. Houdini

    Houdini New Member

    Messages:
    17
    State:
    Maryland
    Im looking to fabricate some rod holders, any sugestions / pics will be very helpful. Im working with a 14' alumacraft.
     
  2. Big Dav

    Big Dav New Member

    Messages:
    1,016
    State:
    Southwest

  3. rspd507

    rspd507 New Member

    Messages:
    729
    State:
    Rising Sun,IN
    Ken,
    I went to the BOC library and found a design made from PVC pipe. My buddy actually made some and they seem like they will work fine. I just mounted them to a 2x4 with a 1/4 inch lag bolt. Cut the 2x4 at an angle matching that of the side of my boat, cut the length kind of tight and wedged it in. Then cut a short piece of 2x4 put it under the center of the first one for support. hope this helps. rspd507