Easy-to-make Bank Rod Holder

Discussion in 'Fishing Rod Holder Review' started by JHalden, May 17, 2009.

  1. JHalden

    JHalden New Member

    Messages:
    106
    State:
    NorthCalifornia
    Recently when I was fishin on the coast near Oregon for steelhead i saw that everyone up there uses these awesome easy to make rod holders. You will need:

    rebar
    PVC fat enough to hold rod handle
    3 hose clamps
    duct tape or similar

    Just take some fat pvc cut it to fit a long handle (about 12"). Fit it next to the rebar with the 3 hose clamps with enough of the rebar sticking up that you can hammer it into the ground. Tape all around the pipe and hoseclamps and its done. Just dont forget a hammer when you bring it fishing. :0a26:
     
  2. Mickey

    Mickey New Member Supporting Member

    Messages:
    14,592
    State:
    Illinois
    Thanks for sharing the idea . Appreciated.
     

  3. Cody King

    Cody King New Member

    Messages:
    7
    State:
    Arizona
    sounds good ill have to try that one day.
     
  4. daystarchis

    daystarchis New Member

    Messages:
    11,521
    State:
    Clovis Cali
    Good idea brother:wink:
     
  5. JHalden

    JHalden New Member

    Messages:
    106
    State:
    NorthCalifornia