Dishwasher Help

Discussion in 'Other Repairs' started by Billy Jo, Jun 5, 2007.

  1. Billy Jo

    Billy Jo New Member

    Messages:
    148
    State:
    Peoria , Arizona
    I have a wirlpool dishwasher Mod#DU1055xtp. The clean light is blinking code 7 and the washer will not start. Are there any appliance repairmen out there that could give an idea were to start?
    Thanks Bill
     
  2. Ol Man

    Ol Man New Member

    Messages:
    3,170
    State:
    Illinois
    Have you tried holding down the start button till it resets???

    Ol' Man
    ~~~~~~~~~~~~
    When someone points skyward, it's the fool that looks at the finger.
     

  3. Billy Jo

    Billy Jo New Member

    Messages:
    148
    State:
    Peoria , Arizona
    Jeb, I held down start buttom but that dosen't work. Do you know of anythang else that may work?
    Thanks for your help. Billy jo
     
  4. teaysvalleyguy

    teaysvalleyguy New Member

    Messages:
    9,751
    State:
    GC, OHIO
    Not sure if this will help, but what I found online doing a search.


    F/07 Motor Control Unit Error

    The Central Control Unit has detected a short in the motor control unit. If a failure occurs during high-speed spin, the door will be unlocked after 3 minutes.


    Check wire harness connections between the Drive Motor and the Motor Control Unit (MCU), and between the MCU and the Central Control Unit (CCU)
    Check the MCU
    Check the Drive Motor
    Check the Wire Harness
     
  5. Ol Man

    Ol Man New Member

    Messages:
    3,170
    State:
    Illinois
    I shot my wad, Bill... try asking them...

    http://www.whirlpool.com/custserv/email_form.jsp

    Ol' Man
    ~~~~~~~~~~~~
    California: As Seen on TV