Check out the specs on this boat

Discussion in 'General Conversation' started by SubnetZero, Jun 12, 2006.

  1. SubnetZero

    SubnetZero New Member

    Messages:
    1,619
    State:
    Sherman IL
    Was surfing around the net and stumbled across this.
    I dont know anything about this company or their boats, but the specs looked pretty good ..


    Boat Length: 20' 1"

    Beam: 86"

    Weight: 1200 lbs.

    The standard features in a Big "O" Boat

    Custom Gel coat Colors
    Custom Matched Upholstery
    6 gauge Troll Motor wiring
    Automatic bilge pump switch
    1500 GPH Bilge pump
    Front 25 Gallon insulated round livewell
    Rear 20 Gallon insulated round livewell
    2 Stainless Steel pedestal plates
    2 750gph Livewell fill pumps
    2 750gph Livewell re-circulating pumps
    Bow Trim and Front livewell controls
    Console Rear Livewell controls
    Built in teardrop bow navigation lights
    Built in rear dome motor mounted light
    Stainless bow and transom eyes
    Control switches
    40 gallon aluminum fuel tank
    Master power switch
    Aluminum transom plates
    Aluminum lids
    Lid Insulation
    2 Full length carpeted rod lockers
    5 lockable storage compartments
    2 Fully insulated coolers
    Teleflex Hydraulic Steering

    Standard Seating on Bass Boat models : 4 B&M seats and 1 center cushion.

    Standard Seating on Flats models: 3 B&M seats and 1 Bench Cushion.

    http://www.bigoboats.com/standard.htm
     
  2. Darrell

    Darrell New Member

    Messages:
    332
    State:
    Illinois
    I bet they are some pricey boats! Nice though. That deck space is awesome! I priced a few boats over the internet. I contacted that Okawqua dealer up in quincy. One of his custom made john boats that I wanted was $32000 bones!!! I couldnt believe it. Very, Very nice boats but I would have to make a living out of fishing to justify it.

    Thanks for the information!


    D