Catfish Angler Forum at USCA banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1,068 Posts
Discussion Starter · #1 ·
Does anybody know how to get the cog gear loose from the side plate, is it a press fit? Also I need help with getting the six pin and weights loose from my spool. I'm doing a complete tear down and cleaning and need help in these two areas. Thanks Mike
 

·
Registered
Joined
·
2,534 Posts
On the left cog wheel there should be a c-clip, or on older reels a screw holding it to the shaft. the brake assembly is attached to the spool with a wire clip. there are 2 notches, or breaks in the center of the spool. simply use a pick, or a small screwdriver and gently pry the wire from it's groove and the brake will slide right off.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top