Catfish Angler Forum at USCA banner
1 - 7 of 7 Posts

·
Registered
Joined
·
199 Posts
Discussion Starter · #1 ·
I am looking for a wiring diagram for a the above outboard(Evinrude). I would like to completely rewire it. The wires are old and brittle. Does anyone have one?
 

·
Registered
Joined
·
3,361 Posts
Bo, there are a couple of places on Ebay that have lots of OEM manuals. I'll usually search by model number and "manual" and they'll usually pop up. You'll have to wade through a lot of the Clymer books for sale, but I found the OMC service and parts manuals for less than $40 with shipping for my motor, saved me hundreds in repairs. Not that the Clymer books are bad, but I like having the same docs the actual mechanics have.
 

·
Registered
Joined
·
199 Posts
Discussion Starter · #6 ·
Bo, there are a couple of places on Ebay that have lots of OEM manuals. I'll usually search by model number and "manual" and they'll usually pop up. You'll have to wade through a lot of the Clymer books for sale, but I found the OMC service and parts manuals for less than $40 with shipping for my motor, saved me hundreds in repairs. Not that the Clymer books are bad, but I like having the same docs the actual mechanics have.
$40 for both? Usually they cost about that for one manual. Good buy! I know i can buy the manuals. I just thought if someone had the wiring diagram i could get started before i purchase one. This is a motor i just traded for. I plan to use it on my skiff boat project. With the new baby on the way things are getting tight around here. So i was holding off on the manual until next month.
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top