any one know how to hook up a fishfinder on a pontoon boat?

[Dude]

any one know how to hook up a fishfinder on a pontoon boat?

[Whistler]

On my pontoon there is a bracket welded onto the back of my right pontoon. The transducer is mounted there so it's just at the same level and the bottom of the pontoon. The wire runs back toward the front of the boat through the pontoon mounts(where it mounts to the deck) and then up through a hole under the console. My depth finder is mounted on the top of the console and has about a 2" dia hole under it. The transducer cable comes up through this. The power cable is plugged into the fuse block and also runs up through this hole to the depth finder. That's about it. Not real hard, but a bit time consuming to get that transducer angled just right. For that follow the directions with your depth finder. Hope this helps.

[Dude]

I like that idea!!!!!! I dont think im into the idea of putting any hole in the toon for the transducer then adding epoxy or caulk to fill it after its mounted . Would you happen to have a pic of the set up you could post sometime. I dont weld but it would be good to show a welder if i choose to do your method. Thanks for the help, this site is so helpful......thanks to all

[joesf]

That is the way mine is set up as well. Most toons already have this bracket on them.

[TDawgNOk]

Check and see if your toon has a bracket on it already. If not, go to your local marina, and check out what they have, and how they have done it.

[Dude]

thanks fellas for the info.